13 lines
564 B
Markdown
13 lines
564 B
Markdown
# IOC
|
|
|
|
## Firmware
|
|
### General
|
|
* All serial links run at 19200 baud
|
|
|
|
### Bootloader
|
|
* The bootloader is a standard Arduino bootloader with the following additions
|
|
* Use ASCII command 'X' to enable byass mode. Everything received on UART RX will be forwarded to UART TX until the next reset.
|
|
* Use ASCII command 'Y' to set the next unit in the chain into bypass mode.
|
|
* Use ASCII command 'Z' to immediately launch into the user firmware
|
|
* Use the following avrdude command to program: `avrdude -p m8 -P /dev/ttyUSBx -c arduino -b 19200 -U flash:w:$(TARGET).hex`
|