42 lines
2.1 KiB
Markdown
42 lines
2.1 KiB
Markdown
# Trashernet
|
|
|
|
|
|
|
|
Trashernet is a very trashy Ethernet stack for FPGAs written in VHDL aiming to cover all OSI layers:
|
|
|
|
* Layer 1, Physical: `trashernet_phy`
|
|
* Layer 2, Data link: `trashernet_mac`, `trashernet_eth`, `trashernet_arp`
|
|
|
|
When writing it, the following were the main design philosophies:
|
|
|
|
1. Standards are nice and all, but this, it just needs to work.
|
|
2. Hardware is expensive, LOC are not. So let's do everything we can inside the FPGA.
|
|
3. If there's a feature that feels optional even though it isn't, it is. See 1. if in doubt.
|
|
|
|
**IMPORTANT:** This code (and HW suggestions) violate the Ethernet standard in many ways. Do not use in proper (especially commercial) products.
|
|
|
|
## Hardware
|
|
|
|
|
|
|
|
* RX: Use resistors behind Ethernet magnetics to reduce Ethernet RX voltage levels (0 +-2.5V) to LVPECL voltage levels (1.65V +-400mV). Or LVDS if your FPGA can't handle LVPECL. Also, pull up/down resistors help to avoid glitchy behavior with no cable connected or little data activity.
|
|
* TX: Meh, a series current limiting resistor is good enough. Drive two outputs differentially to increase the voltage swing. (Technically not true antivalent signals as there's also the "off" state with both disabled.)
|
|
|
|
Notes:
|
|
|
|
* The RX pull up/downs are probably not the best idea, and fixable in a better way. But for now, this shall work -- and suffice!
|
|
* On the TX side, I'm grossly overloading the drivers. A line driver would probably be a good idea. Or you can just parallel multiple outputs ;D
|
|
|
|
## License
|
|
|
|
This Source Code Form is subject to the terms of the Mozilla Public License, v. 2.0.
|
|
|
|
The Trashernet logo uses graphics from [svgrepo.com](https://svgrepo.com), which are released under the Creative Commons CC0 license, granting the right to freely adapt and use them in any context. Thank you for making these available:
|
|
|
|
* Trash can: https://www.svgrepo.com/svg/66604/trash
|
|
* Ethernet jack: https://www.svgrepo.com/svg/292518/ethernet
|
|
|
|
The font used in the logo, "White Rabbit" by Matthew Welch, is also released on a free-to-use basis. Thank you!
|
|
|
|
* White Rabbit: https://www.fontsquirrel.com/fonts/white-rabbit
|